How to Remove a Tree That Fell to a Shed
Storm damage, illness and other injury can all knock a tree down. If a tree falls and lands on the ground, drying and cleaning is a rather straightforward matter; but if it lands on a construction like your shed, then more care ought to be taken. If the shed is damaged, the tree might shift or the shed itself could collapse while you’re working, putting you in danger. Removing a tree which has fallen on a shed ought to be done one bit at a time.
Inspect the fallen tree and shed to ascertain if you need to call a professional tree removal service. If the tree is very big, seems like it might fall further while you work on it or made contact with electric wires when it dropped, it is probably too dangerous to try to remove the tree yourself.
Remove any branches or other large debris that have fallen off of the tree or shed and that may be retrieved without making contact with either. Don’t reach or crawl under the tree when attempting to remove debris.
Trim small branches with gardening tools or a hand saw if they’re at chest level or below. Don’t trim branches over your head, as this can possibly result in injury if the division falls on you.
Put a ladder as near the fallen tree as possible, stabilizing it by bracing it against an undamaged part of the shed or other solid surface. Use a tripod ladder, then have someone hold the ladder for stability or protected the ladder with metal spikes if necessary to include stability.
Trim extra branches out from above, removing as many branches in the trunk as safely possible. This not only makes the trunk more accessible, but also reduces the burden of the tree on your shed.
Cut the section of the trunk that is on your shed into 12-inch sections or smaller, which makes your cuts in the top and using care not to hurt your roof. Eliminate the sections in the roof, and dispose of them by grinding them to mulch, obtaining a permit to burn them utilizing other safe disposal procedures.
Bring down the remaining portion of the tree trunk. Cut a groove halfway through the trunk close to the base on the opposite side of where you want the tree to fall, then cut an angled groove just below it on the other side of the trunk. Meet this angled groove with a straight groove to cut a wedge, leaving just a small portion of the trunk between your initial cut and the wedge. Pull the trunk with a rope if needed to make it fall in the way you desire.
Cut the fallen trunk into little segments. Eliminate them once you dispose of the sections eliminated from the top of your shed.
Grind or dig the tree stump, filling in the hole that is left behind with topsoil or other soil as required.
Clean up the area in and around the shed, removing any snapped twigs, broken glass or other small debris left behind by the fallen tree.
Assess the damage for your shed, which makes repairs or tearing the shed down to build a new one if needed. Check for damage to the roof, dents or other damage to the siding, broken glass, or cracked and broken support beams.