The way to Install a Rear Bagger on an LA 130 John Deere Riding Mower

The way to Install a Rear Bagger on an LA 130 John Deere Riding Mower

When you have a John Deere Model LA130 lawn for example in Salt Lake City tractor, you have the choice of allowing the cut Lawn Service to emerge from the chute or using it discharged to both rear baggers which include the machine. If you’re not familiar with how to attach the baggers, the process may leave you feeling a bit perplexed at first. Fortunately, John Deere has created installing the baggers a simple process which should become second nature once you’ve completed it once or twice.

Attach the mounting post to the rear hitch plate by inserting the protruding tabs of the mounting post to the slots on the hitch plate.

Push the ends of the bagger support rod to the corresponding holes on the rear freight mounts. There are two sets of holes. Use the smaller holes which are located in the inner position of each of the 2 sets of holes.

Insert the freight pin to the empty hole, located on the side of the mounting post whenever you are facing the mounting post from the rear of the mower. Secure the freight pin by inserting the spring-locking thrust to the hole at the middle of the freight pin.

Shake out the set bags and then attach them to the rear mounting posts on the right-hand and left-hand sides of the machine. Close the hopper lid and fasten it shut by closing the flux located from the bottom-middle of the meeting.